Turn TV Test the VOLUME to ensure it works properly.

Once your TV shuts off immediately remove your finger from the SETUP button the code automatically locks in. The LED will blink once and then after 7 seconds it will initiate code The LED will continue to blink every 2 seconds. Press and firmly HOLD down the SETUP button, do not release.Turn on your TV and then stand back approximately 3-5 feet and point the remote at the CENTER of the front.If LED doesn’t light, then the batteries are either in wrong or the batteries are bad. Test Remote by pressing the power button the LED should light indicating that the batteries are in.Close cover with keypad facing away from you by pressing downward (phot C, Step 1) and sliding it toward the front until it is (photo C, Step 2).Insert two AAA batteries into the remote as shown below in photo.Open Cover: With Keypad facing you, first slide dark lens cover away from you (photo A, Step 1) and then lift lid upwards from the back (photo A, Step 2).How To Program Clean Remote Step 1: Install Batteries

Clean remote setup